Skip to main content
Skip table of contents

Analog PS setpoints

This part describes the paramters of the analog process step setpoints.



In use

This switch defines the output of the analog process step setpoint.
If the switch is active, the setpoint is output.


This value defines the output value of the analog process step setpoint.

The input is made in base unit.

The analog process step setpoints must be configured in the JUMO smartWARE Setup variTRON. They can be found as follows:
Configuration > PT Configuration > Process step > 'Name' > Definition > Analog PS setpoints

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.