Skip to main content
Skip table of contents

Digital setpoints

This part describes the parameters of the digital setpoints.



In use

This switch defines the visibility of the digital setpoint in smartWARE Program and the visualization.
If the switch is active, the digital setpoint is displayed according the state definition and together with the icon, which are defined in 'Inputs and outputs'.

Setpoint link 1/2

Each of these selections define an interaction when the setpoint input value is accepted. Possible selections are:

  • ‘No link’ (default) defines that no interaction takes place

  • ‘Only one active digital setpoint’ means that the defined ‘Setpoint’ is deactivated when the setpoint is entered.

Setpoint 1/2

Each of these selections defines a setpoint with which the defined interaction, takes place.

The digital setpoints must be configured in the JUMO smartWARE Setup variTRON. They can be found as follows:
Configuration > PT Configuration > Process step > 'Name' > Definition > Digital setpoints

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.