Skip to main content
Skip table of contents

Section time condition

This part describes the parameter of the section time condition.



In use

If the switch is active, the actual value of the section time is compared with the setpoint value of the section time. If the actual value is greater than or equal to the setpoint, the condition is true.

The section time condition must be configured in the JUMO smartWARE Setup variTRON. They can be found as follows:
Configuration > PT Configuration > Process step > 'Name' > Definition > Section time transition

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.