Skip to main content
Skip table of contents


In addition to the two steps for Init and Exit, the program consists of a sequence of a maximum of 200 sections, the function and presentation of which is determined by the process steps used.
In smartWARE Program, a program can be built up section by section by inserting the appropriate steps into the program from the corresponding pool of suitable process steps.
After a process step has been inserted, the setpoints and the step-on condition defined in the process step are displayed.
The setpoints must now be entered within their limits and at the end the program is saved after a successful plausibility check.
The program is now in the program pool and ready for execution by ProcessTechnology.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.